Graduate Diploma (GDip) in Design Engineering

The program information below was valid for the spring 2018 term (May 1, 2018 - August 31, 2018). This is the archived version; the most up-to-date program information is available through the current Graduate Studies Academic Calendar.

The Graduate Studies Academic Calendar is updated 3 times per year, at the start of each academic term (January 1, May 1, September 1). Graduate Studies Academic Calendars from previous terms can be found in the archives.

Students are responsible for reviewing the general information and regulations section of the Graduate Studies Academic Calendar.

Program information

  • Delivery mode 
    • On-campus
  • Program type 
    • Diploma
  • Study option(s) 

Admission requirements

  • Minimum requirements 
    • Students in the Master of Engineering (MEng) in Mechanical and Mechatronics Engineering program may complete the requirements for the GDip in Design Engineering in conjunction with their MEng requirements.

Degree requirements

    Coursework option:

  • Courses 
    • Students must complete the following courses:
    • Mandatory courses:
      • ME 680 Advanced Design Engineering
      • ME 681 Advanced Design Engineering - Design Project 1
      • ME 682 Advanced Design Engineering - Design Project 2
    • Specific courses: 1 from the following list:
      • ME 538 Welding Design, Fabrication and Quality Control
      • ME 555 Computer-Aided Design
      • ME 559 Finite Element Methods
      • ME 561 Fluid Power Control Systems
      • ME 566 Computational Fluid Dynamics for Engineering Design
    • General courses: 4 additional Faculty of Engineering graduate courses (subject to the approval of the Department).
    • All courses are 600 and 700 level courses and students are not allowed to take more than 2 500 level courses (courses open to both undergraduates and graduates) out of their 8 required courses.
  • Link(s) to courses
Department of Mechanical and Mechatronics Engineering website