The program information below was valid for the fall 2016 term (September 1, 2016 - December 31, 2016). This is the archived version; the most up-to-date program information is available through the current Graduate Studies Academic Calendar.
The Graduate Studies Academic Calendar is updated 3 times per year, at the start of each academic term (January 1, May 1, September 1). Graduate Studies Academic Calendars from previous terms can be found in the archives.
Students are responsible for reviewing the general information and regulations section of the Graduate Studies Academic Calendar.
-
Admit term(s)
- Fall
- Winter
- Spring
-
Delivery mode
- On-campus
-
Program type
- Master's
- Professional
-
Registration option(s)
- Full-time
- Part-time
- Study option(s)
-
Additional program information
- The University of Waterloo does not provide funding for MEng in Mechanical and Mechatronics Engineering students, and the candidates are expected to be self-supporting.
-
Minimum requirements
- An honours Bachelor's degree (or equivalent) in an acceptable discipline from a university of recognized standing, with at least a 75% standing.
-
Application materials
- Résumé
- Supplementary information form
- Transcript(s)
-
References
- Number of references: 2
-
Type of references:
academic
- English language proficiency (ELP) (if applicable)
- Graduate Academic Integrity Module (Graduate AIM)
-
Courses
- Students must complete 8 one-term (0.50 unit weight) graduate level courses (or courses acceptable for graduate credit) and a mandatory CR/NCR communications course (ESL 601R Professional Spoken English or ESL 602R Scholarly Writing in English) which is normally to be taken in the first term of the program. The communication course can be waived at the discretion of the Department. A maximum of 2 500-level courses may be counted for credit.
- At least 2 out of the 8 required courses must be taken from the following list of ME graduate core courses:
- ME 620 Mechanics of Continua
- ME 621 Advanced Finite Element Method
- ME 631 Mechanical Metallurgy
- ME 632 Experimental Methods in Materials Science
- ME 640 Autonomous Mobile Robotics
- ME 649 Control of Machines and Processes
- ME 651 Heat Conduction
- ME 652 Convective Heat Transfer
- ME 653 Radiation Heat Transfer
- ME 662 Advanced Fluid Mechanics
- ME 664 Turbulent Flow
- MEng students completing 1 of the 3 GDip program options are allowed to use their GDip mandatory courses to count toward 2 of the 8 core courses.
- MEng students must attend at least 4 MME research seminars.
- Additional Faculty regulations concerning Master's degree requirements are:
- The candidate must obtain a pass in all courses credited to their program, with a minimum overall average of 70% (a grade of less than 65% in any course counts as a failure).
- At least half of the courses used for credit must normally be Faculty of Engineering courses and the other half need to be Mechanical & Mechatronics Engineering courses.
- Link(s) to courses: for information about these courses, please contact Graduate Studies and Postdoctoral Affairs
- Mechanical and Mechatronics Engineering (ME) courses
